Light aircraft above the clouds

Free practice

SACAA PPL Flight Planning & Performance practice questions

10 free questions with explanations, from LegendSky Ground School

← All free practice questions

About the Flight Planning & Performance exam

Flight Planning and Performance is one of the SACAA Private Pilot Licence theory subjects. It covers how to plan a flight safely: mass and balance, take-off, climb and landing performance, pressure and density altitude, fuel planning, and using the performance charts in the aircraft’s flight manual.

The pass mark for the SACAA PPL theory exams is 75%.

The 10 questions below were written by LegendSky Ground School to match the PPL flight planning and performance syllabus. They are not official SACAA exam questions. Click the answer you think is right: you’ll see straight away whether you got it, followed by an explanation of the right answer and why each of the other options is wrong.

Question 1

On a hot day at a high-elevation airfield, compared with standard conditions you should expect:

  • A. A shorter take-off run
  • B. A longer take-off run and a reduced rate of climb
  • C. No change in performance
  • D. More engine power
Show answer and explanation

Answer: B. A longer take-off run and a reduced rate of climb

Hot air at a high elevation is less dense, so the airfield has a high density altitude. The engine produces less power, the propeller is less efficient, and the wing needs a higher true airspeed to produce enough lift. The take-off run gets longer and the climb rate drops. On the Highveld, always work out performance for the actual temperature and elevation.

Why the other options are wrong

A. Hot, high conditions mean thinner air, which makes the take-off run longer, not shorter.

C. Air density has a big effect on performance, so hot and high conditions definitely change it.

D. A normally aspirated engine produces less power in thin air, not more.

Question 2

An airfield is at 5 000 ft elevation and the QNH is 1003 hPa. Using 30 ft per hPa, what is the pressure altitude?

  • A. 4 700 ft
  • B. 5 000 ft
  • C. 5 300 ft
  • D. 5 600 ft
Show answer and explanation

Answer: C. 5 300 ft

Pressure altitude is what the altimeter reads with 1013 hPa set. Each hectopascal is roughly 30 ft. The QNH is 10 hPa below standard, so the pressure altitude is 10 × 30 = 300 ft higher than the elevation: 5 000 + 300 = 5 300 ft. Pressure altitude is the starting point for most performance charts.

Why the other options are wrong

A. Subtracting would be correct if the QNH were above 1013 hPa. Here it is below, so you add.

B. This ignores the difference between the QNH and the standard setting of 1013 hPa.

D. This applies the correction twice. The difference is 10 hPa, which is 300 ft.

Question 3

The pressure altitude is 5 000 ft and the temperature is 25°C. The ISA temperature at 5 000 ft is 5°C. Using 120 ft per °C, what is the approximate density altitude?

  • A. 7 400 ft
  • B. 5 000 ft
  • C. 6 200 ft
  • D. 10 000 ft
Show answer and explanation

Answer: A. 7 400 ft

Density altitude is pressure altitude corrected for temperature. 25°C is 20°C warmer than the ISA temperature of 5°C at 5 000 ft. At roughly 120 ft per °C, that adds 20 × 120 = 2 400 ft, so the density altitude is about 7 400 ft. The aircraft will perform as if it were taking off from an airfield 7 400 ft above sea level.

Why the other options are wrong

B. This ignores the temperature. 25°C is well above ISA, so the density altitude is higher.

C. 6 200 ft would only allow for 10°C above ISA. Here it is 20°C above.

D. This is far too high. The correction is 20 × 120 = 2 400 ft.

Question 4

An aircraft’s total mass is 800 kg and its total moment is 720 kg·m. Where is the centre of gravity?

  • A. 0.8 m aft of the datum
  • B. 0.9 m aft of the datum
  • C. 1.1 m aft of the datum
  • D. 9.0 m aft of the datum
Show answer and explanation

Answer: B. 0.9 m aft of the datum

The centre of gravity is found by dividing the total moment by the total mass: 720 kg·m ÷ 800 kg = 0.9 m aft of the datum. Each item’s moment is its mass multiplied by its arm, its distance from the datum, and you add them all up first. Then check that the result falls within the centre of gravity limits in the flight manual.

Why the other options are wrong

A. This mixes up the figures. 720 ÷ 800 is 0.9.

C. This is 800 ÷ 720: the calculation done upside down.

D. This is out by a factor of ten.

Question 5

The fuel burn is 30 litres per hour and the planned flight time is 1 hour 40 minutes. How much fuel will the flight use?

  • A. 40 litres
  • B. 42 litres
  • C. 45 litres
  • D. 50 litres
Show answer and explanation

Answer: D. 50 litres

1 hour 40 minutes is 1⅔ hours (about 1.67 hours), not 1.4 hours. 30 L/h × 1.67 h = 50 litres. Treating minutes as a decimal is one of the most common mistakes in fuel planning. When planning a real flight, add taxi fuel, contingency fuel and the required reserve on top of the trip fuel.

Why the other options are wrong

A. 40 litres would only last 1 hour 20 minutes at 30 litres per hour.

B. This treats 1 hour 40 minutes as 1.4 hours. 40 minutes is two-thirds of an hour, not 0.4.

C. 45 litres would only last 1 hour 30 minutes.

Question 6

Compared with taking off into a headwind, taking off with a tailwind will:

  • A. Shorten the take-off run
  • B. Have no effect
  • C. Increase the take-off distance
  • D. Lower the lift-off airspeed
Show answer and explanation

Answer: C. Increase the take-off distance

The aircraft needs a certain airspeed to lift off. With a headwind, part of that airspeed comes from the wind, so the groundspeed at lift-off is lower and the run is shorter. With a tailwind, the aircraft has to reach a higher groundspeed, so the take-off run and the distance to clear obstacles both increase considerably.

Why the other options are wrong

A. A tailwind means you need a higher groundspeed to reach lift-off airspeed, which lengthens the run.

B. Wind has a big effect on take-off distance, because it changes your groundspeed at lift-off.

D. The lift-off airspeed stays the same. What changes is the groundspeed needed to reach it.

Question 7

Which of these conditions will increase the take-off distance?

  • A. Long, wet grass on the runway
  • B. A headwind
  • C. A low air temperature
  • D. A lower aircraft mass
Show answer and explanation

Answer: A. Long, wet grass on the runway

Long or wet grass adds rolling resistance, so the aircraft accelerates more slowly and needs more runway. Other things that increase take-off distance are a higher mass, a high density altitude, an upslope and a tailwind. Use the correction factors in the flight manual for the runway surface rather than guessing.

Why the other options are wrong

B. A headwind shortens the take-off distance.

C. Cold air is denser, which improves performance and shortens the take-off.

D. A lighter aircraft accelerates faster and needs less runway.

Question 8

Taking off above the maximum take-off mass will:

  • A. Reduce the stall speed
  • B. Improve the climb performance
  • C. Only affect the fuel burn
  • D. Increase the stall speed and take-off distance, and reduce climb performance
Show answer and explanation

Answer: D. Increase the stall speed and take-off distance, and reduce climb performance

A heavier aircraft needs more lift, so it has to fly faster at a given angle of attack: the stall speed and take-off speed both increase. It accelerates more slowly, uses more runway, climbs more poorly and puts extra stress on the structure. The maximum take-off mass in the flight manual is a limit, not a guideline.

Why the other options are wrong

A. A heavier aircraft has a higher stall speed, not a lower one.

B. Extra mass makes the climb worse, not better.

C. Being overweight affects every part of performance, as well as the structure.

Question 9

Using a density of 0.72 kg per litre, what is the mass of 100 litres of AVGAS?

  • A. 7.2 kg
  • B. 72 kg
  • C. 100 kg
  • D. 139 kg
Show answer and explanation

Answer: B. 72 kg

Mass = volume × density, so 100 L × 0.72 kg/L = 72 kg. AVGAS is lighter than water, which is about 1 kg per litre, so the mass in kilograms is always less than the volume in litres. Use the density given in the flight manual or in the exam question, because it changes slightly with temperature.

Why the other options are wrong

A. This is out by a factor of ten. 100 × 0.72 is 72.

C. This assumes fuel weighs the same as water. AVGAS is lighter.

D. This divides by the density instead of multiplying.

Question 10

Which speed gives the greatest height gain over the shortest horizontal distance, for clearing obstacles after take-off?

  • A. Vy
  • B. Vne
  • C. Vx
  • D. Vfe
Show answer and explanation

Answer: C. Vx

Vx, the best angle-of-climb speed, gives the most height for the distance covered over the ground, so it is used to clear obstacles near the end of the runway. Vy, the best rate-of-climb speed, gives the most height in the shortest time and is used for a normal climb. Vx is slower than Vy, so only fly it for as long as you need to.

Why the other options are wrong

A. Vy, the best rate-of-climb speed, gives the most height in the shortest time, not over the shortest distance.

B. Vne is the never-exceed speed, the maximum speed for the aircraft.

D. Vfe is the maximum speed with the flaps extended.